Then you get to route the window defroster wire through the soft top sleeve and stuff but that's way too hard to explain without pics.Run the seatbelt through the new plastic trim, install the reused plastic plugs into the trim and snap it into place.From Wiki: A butane torch is a tool which creates an intensely hot flame using butane, a flammable gas. For removal, it may require localized heat (>550☏/260☌), hand tools, and disassembly while hot. Mine came with 2 sets of bolts for the bottom hole, it didn't seem to matter which I used but I thought that was weird. From Loctite: High Strength (Red): Designed to deliver high strength on 14' to 34' (6 mm to 22 mm) fasteners. Install the mounting posts using the supplied bolts.The HT should have come with 2 new trim parts with sections of them cut out to accommodate the hard top mounting posts. The install hardware arrived a few days before the hardtop arrived from the UK. By the way, I bought my hard top from Mike V. Remove the left and right plastic trim parts that the seat belt passes through (unbolt the seatbelt base). 2001 MR2 Spyder, 119whp/1850lbs, Hancook RS-3, D2 Coilovers, big wing.Replace them with the stainless latch parts.Remove the rear tabs near the engine hinge that are body colored painted on the Left and Right side. Update toyota mr-s parts 23-05-14) Luxurypart carbon hardtop with the carbon scoop roof.but if no one posts up I can send you a scan of the install info via PM on Sunday. Thats only 6,000 extra for a hardtop(that sells for 3k-4k) and a full K20a swap that would cost between 6k and 12k to replicate(depending on labor) plus all. Available for: Mazda Miata Roadster (1989-2005) Toyota Mr2-Spyder (1999-2007) Sold In Pairs - A pair of Talon locks includes two sets of brackets and bases to secure two OEM latches against tampering. Genuine factory OEM Toyota hardtops for your 2000-2006 MR2 Spyder These are used OEM hard tops, imported from overseas. It was a few years ago so I don't remember the actual instructions. Talon Hardtop Security System for factory hardtops with OEM latches. MR2 Spyder Hardtop OEM Toyota MR2 Spyder Hardtop MR2hardtop - 3,500.00 : FullSpeedTech. Those things above aren't in any instructions but two things I noticed I messed up on the first hard top install. Did it come with all mounting hardware and modified plastic trim pieces?Ģ things on that - when you pull the seatbelts through the old trim pieces, be careful not to pop the retaining rivet off of the seatbelt when you pull it through the plastic trim that is being replaced.Īlso, when installing the new plastic trim using the plastic rivet(s) that holds it in place, do not push too hard otherwise you will 'crease' the trim and create a white mark from pushing to hard (like when you fold a credit card in half, you get that white stress line from bending plastic).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |